The four-wheel drive version of the Vanagon , made between 1986 and 1991. using a viscous coupling arrangement, the front wheels could be made to automatically provide pulling power (at any time the rear wheels began to slip or spin). This term also applies to the four-wheel drive EuroVans , which are unfortunately not imported into the United States.
Westfalia is a camper-conversion brand, not a Transporter generation. Gerry’s preserved FAQ describes Westfalia as one of several companies that converted VW Transporters and says it was generally the camper version imported and sold through Volkswagen dealers in the United States at that time. Roof, interior, and equipment depend on the specific vehicle and year.
In Gerry’s preserved FAQ alignment article, “Camper model” refers to the heavier Vanagon Syncro camper configuration, with separate alignment values from lighter non-camper vehicles. A Gerry discussion on 15 October 2003 about the “official” Syncro alignment specs quotes the chart for 1986–1991 Syncro campers with dual batteries up front; a 1999 thread separately asks about an almost-empty 1986 Syncro. These historical sources show why the exact load and configuration matter, not a current alignment specification. Use service data for the specific vehicle.
Set of brake shoes for Vanagon/T25 models, excluding Syncro with 16-inch wheels
Shaft that drives the differential in a vehicle
Shaft that transmits power from the engine to the gearbox
Exhaust pipe located before the rear silencer in Vanagon/T25, excluding Syncro models
Type of differential that limits the slip between the wheels
Electrodes that produce a spark to ignite fuel in an engine
In a Syncro drivetrain, a driveshaft decoupler disconnects the prop shaft so the front axle is no longer driven through it; it is not the front differential lock. A Gerry discussion on 16 May 2004 compares the original non-viscous-coupling layout, which used a driveshaft decoupler, with viscous-coupling Syncros while debating front-lock behavior. The thread is historical community discussion, not a retrofit procedure; identify the drivetrain configuration before interpreting parts or controls.
